Do you prefer...

Sunday, September 20, 2009

Day 16

Day 16

Today I didn't get tapped until around 11:15 a.m. which means I won't be untapping until about 2:30 a.m. It was a bit rough going this morning. I don't really know why but it seemed everything was irritating me. The thing is, to tape properly, the penis needs to be fully erect. If this is an issue even a little the process is slow going at best. But, because the mind is focused on getting the tape situated properly, it's hard to focus on getting hard. Usually I can throw on some porn and about 45 seconds later I'm erect enough to tape, I just have to get all the way taped in 15 seconds (or less) or the erection is gone. It's sort of a race against time. Once taped though all is fine and I can just strap up.

Okay, just in case I haven't really explained the process I'll do that now.

1. I prepare the T-Tape by cutting a 5Lx2W piece of wax paper for the tape backing and fold it length ways bringing the width to 1 in.

2. I pull out a piece of tape 5 in. long and place the wax paper backing at the bottom just slightly hanging over the bottom most edge.

3. I then take another 5 in. piece of tape and mate the two sticky sides against each other as evenly as possible.

4. Then I fold open the section that is not adhered because of the wax paper. This makes a T formation.

5. From here the tape is ready to go on. So I crease the T section and remove the wax paper backing.

6. At this point it's time to get an erection so that I can apply the tape. I do what is necessary to get myself hard.

7. I then pull the shaft skin taught toward my body and locate the POE (point of equalibrium which is the point where the outer and inner shaft skin can be pulled evenly).

8. I position the tape with the crease of the T on the POE and wrap it as evenly as possible around the circumference of my shaft.

9. Once the tape is on, I try to maintain an erection for at least a minute to allow full adhesion to take place.

10. After the tape is on good, I put together a pad for the tip of my glans. The reason for this is to collect any moister that may become present while strapped. This is made from toilet paper, paper towel, and gauze and it's placed in and held by the pressure of the glands pressing against the taped foreskin.
11. Once everything is in place the tape ring is pulled forward, placing the skin to be stretched up over, in part, the glans and collected into a bunched tab to allow it to be held by the strap.

12. When a comfortable position is made with the tab it is folded over to make for more bulk surfice for the strap clamp. Then the clamp is applied to the bulk tab

13. The strap is then left to hang while boxers(-briefs) are put on and then the strap is fed through the 'fly' of the boxer.

14. After everything is fed throught, the strap is brought around the waist around the back and connected to the other side opposite the side the penis is pointing. (note: I switch sides each day to ensure most equal and consistant pressure as I feel it'll make for a more even out come in the end)

15. Once the strap is on I adjust the tension of the strap to make sure I feel pressure but NO pain. If there is pain, I adjust again until there is none.

16. After that, I personally put on another pain of trunk type underwear with the sole purpose of putting something soft between my stretched shaft skin and whatever pants I am going to be wearing that day. All done

This is the general process and I do this all in under 10 minutes most of the time. Since I do this daily, sometimes I will make 5-7 T-Tapes at a time, though recently I find it best to make it right before or the night before tapping as the wax paper releases easier then the ones allowed to sit over days. If they've sat for a couple days the adhesive on the tape becomes rather stuck to the wax paper and can cause a host of frustrations.

I will try my best to post these steps again for tomorrows stretching in a step by step pictorial sans the words as they are posted above. I will do the full 16 step process in just pictures to show each step clearly for those who may be interested in following this method.

That's all for today and I hope it can help someone out there. Sorry it took so long to post this, I got busy with home keep up. Hey, what can I say, life happens... Even when restoring. ;-D LOL!

Blessed Be


-- Posted via iPhone

No comments:

Post a Comment